Connections and Valves
-
Tri-Clamp Gasket
Replacement silicone Tri-Clamp Gasket, suitable for all standard tri-clamp fittings. These are all beaded to fit the tri-clamp groove unless specified otherwise.
Currently available in these sizes:
- 3.81cm (1.5")
- 5.08cm (2") (flat, not beaded)
- 5.08cm (2") - (also used as Grainfather conical plug seal)
- 7.62cm (3")
- 10.16cm (4")
- 15.24cm (6")
- 20.32 (8")
Note: photo shows 7.62cm (3") beaded option. Colour may vary.
-
Tri-Clamp Cap - 3" to 1.5" Reducer
Tri-Clamp Cap - 3" to 1.5" Reducer. Great for allow you to use existing 1.5" tri-clamp fittings on a 3" TC fermenter.
Note: 3" gasket not included.
-
Hole Punch - 22mm and 33mm
These hole punches are great for making really clean holes that are free of burrs. The holes made with this type of punch are significantly better than a hole made with a carbide drill bit or many other hole saws. These produce clean holes and can be used in mild sheet steel up to 3mm thick or stainless steel up to about 1.5mm thick. If you are looking for a really easy way to make really clean holes this is the best product for the job.
Available for a 22mm or 32mm hole.
-
1/2" Inch BSP 316 stainless hex Back Nut
Used in conjunction with a hex nipple, washer and ball valve assembly. -
SS Brew Bucket O-Ring Replacements
SS O-Ring replacements for Brew Buckets and Mini Brew Buckets.
For use on Brew Bucket 3/8" Ball Valve. Includes:
- 4 pcs 8.5 mm x 1 mm Buna N 70 O-rings
- 2 pcs 16mm x 1.8 mm Buna N 90 O-rings
- 6 pcs total in this set (enough to replace all o-rings on one Brew Bucket valve)
From: Ss Brewing Technologies, USA -
Teflon Thread Seal Tape
Teflon PTFE Thread Seal Tape for sealing threaded joints.
Size: 12mm wide x 10m
Colour: Yellow
Nobody likes leaky fittings in the brewhouse - a little bit of teflon thread tape can make all the difference.